Fire Candidate Physical Ability Test

Candidate Physical Ability Test (C.P.A.T.)


The City of Phoenix will not be conducting a CPAT. Proof of successful completion of a Candidate Physical Ability Test (CPAT) from a licensed agency is required at the time of final selection interview. The certification can not be more than 6 months old at the time of the final selection interview. To learn more about registering for a CPAT course or scheduling to take a registered CPAT test, please contact Maricopa County Community Colleges or the National Testing Network.

The Fire Service Joint Labor Management Wellness/Fitness Initiative Candidate Physical Ability Test© (CPAT) consists of eight separate events.  To confirm the agency you select is licensed click HERE.  The CPAT is a sequence of events requiring the candidate to progress along a predetermined path from event to event in a continuous manner.
 

This test was developed to allow fire departments a means for obtaining pools of trainable candidates who are physically able to perform essential job tasks at fire scenes. See below for descriptions and pictures of the eight separate events.

  • Stair Climb
  • Hose Drag
  • Equipment Carry
  • Ladder Raise and Extension
  • Forcible Entry
  • Search
  • Rescue
  • Ceiling Breach and Pull

This is a pass/fail test based on a validated maximum total time of 10 minutes and 20 seconds.


Event 1: Stair Climb
Using a StepMill stair-climbing machine, this event is designed to simulate the critical task of climbing stairs in full protective clothing while carrying a high-rise pack (hose bundle) and firefighter equipment. This event challenges aerobic capacity, lower body muscular endurance and balance.
Participants wear a 12.5-pound weight on each shoulder to simulate the weight of a high-rise pack. Immediately following a 20-second warm-up period at a rate of 50 steps per minute, the timed part of the test starts as indicated by a proctor.
There is no break in time between the warm-up period and the actual timing of the test. During the warm-up period, dismounting, grasping the rail, or holding the wall to establish balance and cadence is permitted. The timed part of the test lasts three (3) minutes at a stepping rate of 60 steps per minute.
Failure can occur by falling or dismounting three times during the warm-up
period, or by falling or dismounting the StepMill after the timed CPAT begins.
During the test, the participant is permitted to touch the wall or handrail for
balance only momentarily; if that rule is violated more than twice during the test failure will result.

 

Event 2: Hose Drag
This event is designed to simulate the critical tasks of dragging an uncharged hose line from a fire apparatus to a structure and pulling an uncharged hose line around obstacles while remaining stationary. This event challenges aerobic capacity, lower body muscular strength and endurance, upper back muscular strength and endurance, grip strength and endurance, and anaerobic endurance. A hoseline nozzle attached to 200 feet of hose is grasped and placed over the shoulder or across the chest. While walking or running, the participant drags the hose 75 feet to a pre-positioned drum, makes a 90° turn, and continues an additional 25 feet. After stopping within the marked box, the candidate drops to at least one knee and pulls the hoseline until the 50-foot mark crosses the finish line. During the hose drag, failure results if the participant does not go around the drum or goes outside of the marked path. During the hose pull, a warning is given if at least one knee is not kept in contact with the ground or if the knees go outside the marked boundary line; a second warning constitutes failure.

 

Event 3: Equipment Carry
This event uses two saws and a tool cabinet replicating a storage cabinet on a fire truck. It simulates the critical tasks of removing power tools from a fire apparatus, carrying them to the emergency scene, and returning the equipment to the fire apparatus. This event challenges aerobic capacity, upper body muscular strength and endurance, lower body muscular endurance, grip endurance, and balance. The candidate must remove the two saws from the tool cabinet, one at a time, and place them on the ground. Then he/she picks up both saws (one in each hand) and carries them while walking 75 feet around a drum, then back to the starting point. Placing the saw(s) on the ground to adjust a grip is permitted. Upon return to the tool cabinet, the saws are placed on the ground, then picked up one at a time, and replaced in the cabinet. Dropping either saw on the ground during the carry will result in immediate failure. A warning will be given for running; a second warning constitutes a failure.

The best thing about being a Phoenix Firefighter is:
“Commitment to fitness.
The worst thing is commitment to fitness!”
Crystal Rezzonico,
Fire Captain - 18 years w/PFD


Event 4: Ladder Raise and Extension
This event, which uses two 24-foot aluminum extension ladders, is designed to simulate the placement of a ground ladder at a fire structure and extending it to the roof or window. This event challenges aerobic capacity, upper body muscular strength, lower body muscular strength, balance, grip strength, and anaerobic endurance. The participant must walk to the top rung of one ladder, lift the unhinged end from the ground, and walk it up hand over hand until it is stationary against the wall. Then he/ she immediately proceeds to the other pre-positioned ladder, stands with both feet within the marked box, extends the fly section by pulling the halyard rope hand over hand until it hits the stop, then lowers it in back to the starting position. Immediate failure will result if the ladder is allowed to fall to the ground, if control is not maintained in a hand-over-hand manner, or if the rope halyard slips in an uncontrolled manner. Missing any rung during the raise or allowing the feet to be placed outside of the boundary results in a warning; a second warning constitutes a failure.
 

Event 5: Forcible Entry
This event uses a mechanized device that measures cumulative force and a 10-pound sledgehammer. It simulates the critical tasks of using force to open a locked door or to breach a wall. This event challenges aerobic capacity, upper body muscular strength and endurance, lower body muscular strength and endurance, balance, grip strength and endurance, and anaerobic endurance. For this event, the candidate uses the sledgehammer to strike a measuring device in a target area until the buzzer activates. Feet must be kept outside the toe-box at all times.
Failure results if the participant does not maintain control of the sledgehammer and releases it from both hands while swinging. A warning is given for stepping inside the toe-box; a second warning constitutes a failure.
 

Event 6: Search
This event uses an enclosed search maze that has obstacles and narrowed spaces. It simulates the critical task of searching for a fire victim with limited visibility in an unpredictable area. This event challenges aerobic capacity, upper body muscular strength and endurance, agility, balance, anaerobic endurance, and kinesthetic awareness. For this event, the candidate crawls through a tunnel maze that is approximately 3 feet high, 4 feet wide, 64 feet in length, and has two 90° turns and multiple obstacles. In addition, there are two locations where the dimensions of the tunnel are reduced. If at any point the participant chooses to end the event, he/she can call out or rap sharply on the wall or ceiling and will be assisted out of the maze, although doing so will result in failure of the event. Failure also will occur if the candidate requests assistance that requires the opening of the escape hatch or opening of the entrance/exit covers.
 

Event 7: Rescue
This event uses a weighted mannequin equipped with a shoulder harness to simulate the critical task of removing a victim or injured firefighter from a fire scene. This event challenges aerobic capacity, upper and lower body muscular strength and endurance, grip strength and endurance, and anaerobic endurance. The participant grasps a 165-pound mannequin by the handle(s) on the shoulder(s) of the harness (one or both handles are permitted), drags it 35 feet, makes a 180° turn around a pre-positioned drum, and continues an additional 35 feet to the finish line. Grasping or resting on the drum is not permitted, but the mannequin may touch the drum. The candidate is permitted to drop and release the mannequin to adjust his/her grip. The entire mannequin must be dragged across the finish line. Grasping or resting on the drum at any time results in a warning; a second warning constitutes a failure.
 

Event 8: Ceiling Breach and Pull
This event uses a mechanized device that measures overhead push and pull forces and a pike pole. The pike pole is a commonly used piece of firefighting equipment that consists of a six-foot long pole with a hook and point attached to one end. This event simulates the critical task of breaching and pulling down a ceiling to check for fire extension. It challenges aerobic capacity, upper and lower body muscular strength and endurance, grip strength and endurance, and anaerobic endurance.
After removing the pike pole from the bracket, the participant places the tip of the pole on a 60- pound hinged door in the ceiling and pushes it three times while standing within the established boundary. Then, the pike pole is hooked to a 80-pound ceiling device and pulled five times. Each set consists of three pushes and five pulls; the set is repeated four times. A pause for grip adjustment is allowed. Releasing one’s grip or allowing the pike pole handle to slip does not result in a warning or constitute a failure. The candidate may re-establish his/her grip and resume the event. If a repetition is not successfully completed, the proctor calls out “MISS” and the apparatus must be pushed or pulled again to complete the repetition. This event and the total test time ends when the final pull stroke repetition is completed and the proctor calls “TIME.” A warning is given for dropping the pike pole to the ground or for feet straying outside the boundaries; a second warning of either violation constitutes a failure. 

 

Summary

In these events, the candidate wears a 50-pound vest to simulate the weight of self-contained breathing apparatus (SCBA) and firefighter protective clothing. An additional 25 pounds, using two 12.5-pound weights that simulate a high-rise pack (hose bundle), is added to the shoulders for the stair climb event. Throughout all events, the participant must wear long pants, a hard hat with chinstrap, work gloves and footwear with no open heel or toe. Watches and loose or restrictive jewelry are not permitted. All props were designed to obtain the necessary information regarding physical ability. The tools and equipment were chosen to provide the highest level of consistency, safety and validity in measuring the candidate’s physical abilities. The events are placed in a sequence that best simulates fire scene events while allowing an 85- foot walk between events. To ensure the highest level of safety and to prevent exhaustion, no running is allowed between events. This walk allows approximately 20 seconds to recover and regroup before each event. To ensure scoring accuracy, two stopwatches are used to time the CPAT. One stopwatch is designated as the official test time stop-watch, the second is the backup stop watch. If mechanical failure occurs, the time on the backup stopwatch is used. The stopwatches are set to the pass/fail time and countdown from 10 minutes and 20 seconds. If time elapses prior to the completion of the test, the test is concluded and the participant fails the test. 

 


Hiring ProcessPFD Logo with Banners
Here is information on each step in the hiring process, including the written exam, the eligibility list, oral board interviewing, background checks, physicals and drug testing.

EMT Certification
Every Phoenix Firefighter is required to obtain and maintain Emergency Medical Technician (EMT) Certification.

Firefighter Recruit Training
Firefighter Recruit is an employment classification for entry level members assigned to the Phoenix Fire Training Academy for Firefighter Recruit Training.

Affinity Groups
An Affinity Group is a group of people formed around a shared interest or common goal who support each other and work together.  There are several groups associated with the fire department.  Please contact them directly.

Firefighter I & II Certification
Firefighter I & II Certification may be obtained from a number of sources.  To assist you we have identified a few.

Cadet Program
The Phoenix Fire Department Cadet Program was started in 1975. The purpose of the program is to provide cadets with hands-on emergency medical training, work experience at fire stations, training in firefighter skills and volunteerism for the community. 

Fire Science Classes
The Maricopa Community College District is a great resource to prepare you for a career as a firefighter. Current and former firefighters work as adjunct faculty and are there to help you prepare for a career as a firefighter. Click here to locate Fire Science Classes.

Fitness Preparation
Fitness Preparation is a very important part of the employment process.  

Sample Recruitment Packet
A Sample Recruitment Packet is available for downloading.  This is a sample of what will be available during the recruitment process.

Frequently Asked Questions
Click here for answers to frequently asked questions.